Andymark Plaction Wheel, 6" Wedgetop
Molded polycarbonate, 6 inch diameter traction wheel with wedgetop tread.

Specifications
# Outside diameter: 6 inch
# Inside diameter: 0.965 inch
# Bearing bore: 1.124 inch x 0.25 deep (both sides)
# Tread width: 0.90 inch exposed, designed to capture 1.00 inch wide tread
# Width at hub: 1.54 inch
# Weight: 0.81 pound
# Included hardware: 6 - #10-32x1.25 SHCS and nylock nuts
# Load capacity: 200 pounds (estimated)
# Tread included: Wedgetop conveyor belting, natural rubber material

This wheel is designed to capture 1" wide conveyor belt tread between 2 wheel halves. The 6 screws can be loosened by 1/8 inch to install the desired tread.

You can pick your hub by fitting any of the AndyMark Hubs (except the Small DD Globe Hub) to this wheel. Hubs are NOT included in the price of the wheel.

Bearings with a 1.125" od can be pressed into this wheel. The wheel takes 2 bearings, one on each side. Bearings are NOT included in the price of this wheel.

This wheel is designed so that a 5" PVC schedule 40 pipe can be inserted between the two wheel halves, and a wider wheel can be created.

Weight: 1.0 lbs.


$29.00